top of page
  • Writer's pictureJon

How to 3D Print an Aircraft - Series 2 Part 11 - The First Print

In this episode we finalise the model and move it over to the slicer, Cura. On my first run through Cura I noticed that there may be some difficulty printing the inside features, the spar holes etc, so I went back into Fusion and showed you a technique for adding supports where they are needed in a solid model.



After a weekend of printing the fuselage looks great and weighs in at just 170g. Next up will be the fin then onto printing the wings.






131 views1 comment

Recent Posts

See All
Post: Blog2_Post
bottom of page