top of page
  • Writer's pictureJon

How to 3D print an Aircraft - Series 2 Part 8 - Servo cuts

This episode is a nice short one. We make the servo cuts and wire channels for the elevator (canard) servos. This pretty much finishes up the Canards ready for the slicer. I am going to make one more change, I plan to extend the 10mm diameter cut 5 cm into the wing so that the 10mm rod that is glued into the fuselage will extend into the wing to enforce the join. I'll try to remember to include it in a future episode.

44 views0 comments

Recent Posts

See All


Post: Blog2_Post
bottom of page